020 Tranny constant mesh question

[corylang@dccnet.com (Cory Langford)]

If it is 1st to 2nd, I have had two trannies where that syncro went.
Similar problem, I ended up shifting 1st to 3rd.




At 09:13 AM 06/08/2002 -0400, Wes Brockway wrote:
>I know this transmission is a constant mesh transmission meaning all
>gears are turning all the time. Is it possible for something to break in
>the transmission so that one of the gears doesn't?
>
>My problem, sitting still, engine off or idling, the tranmission goes
>into all gears just fine. At slow acceleration I can shift from 1st to
>2nd ok, not great but ok. The faster I go before shifting to 2nd the
>harder it is and if I wind out 1st the transmission simply will not go
>into 2nd. I have to skip 2nd and go into 3rd.
>
>2,3,4th gear synchronizers have been replaced.
>All motor mounts have been replaced.
>All shift bushings have been replaced.
>Shift alignment has been checked many times.
>
>Guys at the gathering I hate it but I missed getting up there today for
>lots of reasons. I know it's gonna be a great weekend. Wish I could have
>made it.
>
>