Removing the flywheel

[drew@dyermaker.cs.uoguelph.ca (drew)]

These bolts are 12 point 9mm head - you can get a decent 12point 9mm from
Craftsmen (sears) or a crappy one from just about any off the shelf
off-shore metric set.

Drew

On Fri, 28 Jun 2002, Bill Collins wrote:

> I'm trying to remove the flywheel from the engine on my '86 (JH, 8V engine).  Bentley just says to remove the bolts, but the heads on these bolts don't look like anything I have seen before.  They look kind of like the 12 point tool used for the CV joints or head bolts.  Am I just looking at some really messed up bolt heads, or is there a special tool needed here?  If so, what's it called?
> 
> Bill
> 
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
> 

Drew MacPherson - '84 Wolfsburg Edition Scirocco TurboDiesel