Re: Fan switch wiring harness is shot any suggestions???

["Steven Toughill" <stoughill@home.com>]

try this:

run a wire with a 30 amp fuse from the positive of the battery to the fan
switch.
then run another wire from the fan switch to the fan
and lastly run a wire from the other terminal on the fan to the negative of
the battery.
put dielectric grease or vasoline on all the bare connections to protect
them from corrosion.

also seltezer water is great for netrualizing battery acid and corrosion.

Steven Toughill
ASE Cert. VW Technician
Volks-Tech
-----Original Message-----
From: Gary Huff <ghuff@htech.com>
To: 'scirocco-l@scirocco.org' <scirocco-l@scirocco.org>
Date: Tuesday, June 08, 1999 1:36 PM
Subject: Fan switch wiring harness is shot any suggestions???


>Listers,
> My fan switch wiring harness is shot, one of the wires is so
>corroded it barely makes contact, and its  frayed. I noticed that the
>plug is sealed where it goes into the fan switch at the bottom of the
>radiator. Coul I just run new wires, and leave the switch unprotected?
>Can I order a new wiring harness for this switch? Any input is
>apprecciated as the car is running very hot without the fan. Thanks,
> Gary
>Huff
> Highland
>Technologies
>
>301-306-8200 X. 283
>
>--
>To unsubscribe, send "unsubscribe scirocco-l" to majordomo@scirocco.org.
>If you experience other problems, email: scirocco-l-probs@scirocco.org
>
>


--
To unsubscribe, send "unsubscribe scirocco-l" to majordomo@scirocco.org.
If you experience other problems, email: scirocco-l-probs@scirocco.org