Testing while fuel system down

[ydrogs at gmail.com (Gordy Stedman)]

On 3/29/07, Dan Bubb <jdbubb@verizon.net> wrote:
>
>
> Last you probably will need to purge any air from the system. You can
> probably do this just by cranking, but while you've got the setup (fuel pump
> running, injectors pointed into some container) you might want to pull the
> air flow plate up for a couple seconds until only fuel comes out of the
> injectors.
> HTH
> Dan

Good advice.  When pulling up on the air flow plate pull it to the top and
make sure you hear the injectors make a high pitched squeal.  That means
they are fully open deliveing max fuel when the air flow plate is letting
the max amout of air in.  Also remember to lubricate the roller bearing on
the air flow plate arm before you install the fuel distributor so it does
not stick on you in the future.  Can't wait to hear that you got it running
again.
-- 
Gordy
MK1 x 4