[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

timing belt cover @#$%!?

Subject: timing belt cover @#$%!?
From: wolfsbrg8v at bellsouth.net (wolfsbrg8v@bellsouth.net)
Date: Fri Nov 18 04:18:41 2005
In-reply-to: <6155f0910511171807y52da60a9sbc97d7642e0b852c@mail.gmail.com>
References: <op.s0dfmbscqb5u7f@host-67-35-41-212.asm.bellsouth.net> <6155f0910511171807y52da60a9sbc97d7642e0b852c@mail.gmail.com>


Don -- thanks for the pictures!  The cover will pry back a quarter inch, so I know I can get a wrench on that hex part.

Leo
84.5 wolfsburg

On Thu, 17 Nov 2005 21:07:59 -0500, Don Walter <dswalterwi@gmail.com> wrote:

> These pictures may help:
> http://scirocco.dyn.dhs.org/vw/list/Don_Walter/Pulley_Cover/
> The hex nut part is 13mm
>  If you can slide a wrench in there you can stop it from spinning.

Follow-Ups:
- timing belt cover @#$%!?
  - From: roccit_53 at scirocco.cs.uoguelph.ca (C Boyko)

References:
- timing belt cover @#$%!?
  - From: wolfsbrg8v at bellsouth.net (wolfsbrg8v@bellsouth.net)
- timing belt cover @#$%!?
  - From: dswalterwi at gmail.com (Don Walter)

Prev by Date: [OT] Stereo/sub/amp install advice needed
Next by Date: [OT] Stereo/sub/amp install advice needed
Previous by thread: timing belt cover @#$%!?
Next by thread: timing belt cover @#$%!?
Index(es):
- Date
- Thread