Poly control arm bushings

[jdbubb at verizon.net (Dan Bubb)]

Don't forget you have to push the old bushings off.
A press is nice to do this, but I've done it with a vice.
Probably could do it with a torch too, but that's just messy and stinky as 
hell.
Dan
who doesn't much give a crap about poly ;^)

----- Original Message ----- 
From: "Nate Mellom" <doubt@inwave.com>
To: "marc_scirocco" <marc_scirocco@sympatico.ca>; "Scirocco list" 
<scirocco-l@scirocco.org>
Sent: Thursday, May 26, 2005 11:52 PM
Subject: Re: Poly control arm bushings


> <http://www.parts4vws.com/catalog/product_detail.asp?PartNumber=22%2D201>
> I think I see what you're saying, the fronts are 2 part, the rears one 
> piece.  I've been doing some research, should they be lubed before 
> installation?
> Nate
>
>
> marc_scirocco wrote:
>> The front A-Arms poly bushings are two pieces design. You just lube them,
>> and slide them from both sides. Once you can eyeball your poly bushings,
>> you'll figure what I am trying to explain here... ;-)
>>
>> Cheers.
>>
>> Marc
>>
>>
>>>I'm getting my Total Poly kit from the Potter peeps tomorrow, and I plan 
>>>on installing most of it this weekend, including the control arm 
>>>bushings.  I might have access to a press if need be, but can I install 
>>>them with a C clamp? Any other tips?
>>>Thanks!
>>>Nate
>>>
>>>
>>
>>
>>
>>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>