9mm 12 point socket

[area53 at validpath.com (Jeff Toomasson)]

Sounds like you'll have to go Sears. That's where I got mine...

C Boyko wrote:

>I have the right socket, and let me tell you, it's not an easy one to find.
>(9mm, 12 point) But I'd ask Snap-On again, they should carry them. Princess
>carries the larger one you may also want to get if the crank bolt needs it,
>for timing later on. Can't recall the size, or if the 16V needs that one. 
>
>Cathy
>
>
>  
>
>>flywheel-to-pressure plate bolts are 9mm 12pt socket alright, but NOT
>>triple-square.
>>in other words, its a bolt head, not an allen socket.
>>i've got a 9mm 12 pt in my craftsman set in 1/4 / 3/8 / 1/2 drive.
>>you probably have one as well, now that you know its a normal head.
>>hth
>>Al
>>
>>----- Original Message -----
>>From: "Chad Eatock" <ceatock@sympatico.ca>
>>To: "Sciroccolist" <Scirocco-l@scirocco.org>
>>Sent: Saturday, July 30, 2005 4:48 PM
>>Subject: 9mm 12 point socket
>>
>>
>>Went to Toolex and found they don't make 9mm 12 point sockets, only
>>10mm and 8mm...  went to snapon and they don't seem to carry 9mm 12
>>point either...whats up?  are the flywheel bolts 8mm?  I bought the
>>10mm and it is too big, so it must be a 9mm or 8mm??  Anybody know
>>for sure?? _______________________________________________
>>Scirocco-l mailing list
>>Scirocco-l@scirocco.org
>>http://neubayern.net/mailman/listinfo/scirocco-l
>>
>>
>>
>>_______________________________________________
>>Scirocco-l mailing list
>>Scirocco-l@scirocco.org
>>http://neubayern.net/mailman/listinfo/scirocco-l
>>
>>    
>>
>
>
>_______________________________________________
>Scirocco-l mailing list
>Scirocco-l@scirocco.org
>http://neubayern.net/mailman/listinfo/scirocco-l
>
>  
>