MOtor swap questions

[juliemac57 at hotmail.com (Julie Macfarlane)]

It can be done with out it. Just make the bolts finger tight and use a long 
socket to set it in the middle. Then tighten normally.

Easy



Julie Macfarlane
"Its not just a car! Its an adventure!"
1981 MKI 2L 16v w 2Y
Amsterdam NY




>From: Gordy Stedman <ydrogs@gmail.com>
>Reply-To: Gordy Stedman <ydrogs@gmail.com>
>To: Chad Eatock <ceatock@sympatico.ca>, Scirocco-l@scirocco.org
>Subject: Re: MOtor swap questions
>Date: Sat, 30 Jul 2005 18:01:02 -0700
>
> > when taking the clutch and PP and
> > stuff off the old motor and I check it out and its ok do I need special
> > tools to put it back onto the 2.0l?  The bentley says you need alignment
> > tools and holding tools etc.....
>I think they are talking about this tool for the clutch alignment:
><http://www.thepartsbin.com/sitemap/volkswagen~clutch_alignment_tool~parts.html>
>I have two because it is usually so long between clutch changes I
>forget where I put it and just buy another.  If you know what you are
>doing I beleive you can do it with out the tool, but it is cheap and
>basic to use so go get one.  I do not recall a tool for "holding" the
>clutch.
>--
>Gordy
>MK1 x 3
>Audi 80 - Slated for parts car
>
>_______________________________________________
>Scirocco-l mailing list
>Scirocco-l@scirocco.org
>http://neubayern.net/mailman/listinfo/scirocco-l