Lightened flywheels...

[brian_wagner at sbcglobal.net (Brian Wagner)]

Oh you and the ME speak
 
Brian

Dan Bubb <jdbubb@ix.netcom.com> wrote:
Now that you guys have finally gotten down to my level I feel like I can contribute :^)

Removing material from the outside of a spinning object reduces internal stresses and makes it LESS
likely to grenade.
If you were removing material across the entire face of a conventional flywheel (i.e. the flywheel
bolts directly to the crank) that had a heavy outer ring it would weaken the flywheel. But just
removing material from the outer ring and leaving the friction face intact actually makes it capable
of higher RPM before grenading.
Dan

----- Original Message -----
From: "L F" 
To: 
Cc: "Dan Smith" ; "scirocco list" 
Sent: Thursday, January 22, 2004 8:25 AM
Subject: Re: Lightened flywheels...


Am not!

:)
L

Wrong. J



David



-----Original Message-----
From: L F [mailto:rocco16v@netzero.net]
Sent: Wednesday, January 21, 2004 6:40 PM
To: David Utley
Cc: Dan Smith; scirocco list
Subject: Re: Lightened flywheels...



Doubt if properly lightened flywheels are in much danger of grenading; VW engines won't rev high
enough to do that job!!

:)

Larry

(it's a function of the available cams, silly)


> BTW, I have access to new 'lightened' flywheels . These are actually cast
>
> at a lighter weight, which means MUCH less chance of grenading in comparison
>
> to machined flywheels... Weight is 8.5 lbs. For listers, I will sell them
> for $175, shipped to your door, if I can sell at least 3 at once... There
> may
> be more of a discount if there is more interest than that....
> --
> Regards,
> David Utley

_______________________________________________
Scirocco-l mailing list
Scirocco-l@scirocco.org
http://neubayern.net/mailman/listinfo/scirocco-l



_______________________________________________
Scirocco-l mailing list
Scirocco-l@scirocco.org
http://neubayern.net/mailman/listinfo/scirocco-l