Re: alignment specs

["Randy B" <sirocco@telocity.com>]

Let me go measure my toe....(goes to the garage)..........(loud
clang)..........(comes back in the house).....
Ok, it is exactly 2.116" according to my Mitutoyo calipers.
This was measured directly with +/- .005" error.

BTW... That was my big toe on my left foot  :^D

HTH
Randy (just feelin' goofy today)

Dick Wrote:
> Jonas,
> I think you formula is slightly off.  Isn't the sine of the angle =
.0625/23?  Therefore the angle is 0.156 degrees.
> But OTOH, I've never seen an alignment machine that couldn't measure toe
in inches.  This is the standard units of toe.
>
> -Dick-
> 78 Scirocco
> Original Owner



--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org