[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Clutch Saga Continues...



    Well, just one more time on this silly thing I hope.  Just a quick
recap...  Car was going along nicely, and then boom pedal to floor and car
stuck in gear.  I crashboxed it home and went to work.  Thanks to everyone
for their help on this project.  I took the release bearing out and
everything looked good there, then checked the rod per the list suggesstion.
Now, just for kicks, I reversed the release bearing and put it back in.
This way the rod did not go into the bearing at all and thus pushed it out
about an extra half an inch.  Started her up and it clutched somewhat.  I
could put it into gear and it worked.  Unfortunetly, I can not adjust out
the cable enough to make up for the distance.  So, I assume something must
have just bent inside.  Tomorrow I suppose I will start the drop the tranny
project.  Anyway, thanks for everyones help.  If anyone has any other
suggestions I am open...




--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org