Re: screwed up crank shaft pulley allen bolt...

[drew <drew@dyermaker.cs.uoguelph.ca>]

> - chisel and heavy hammering (oh my poor chisel!)

Your poor chisel?  Man, they're light little bucket bolts, you don't have
to use a 10 lb sledgehammer on them...!  A 10 oz ball-peen works fine for
me - much easier to swing in those tight areas.  It's not the force so
much as the jar that breaks them loose.  Try it and you'll see... :)

Now if you're using your screwdriver (especially the one that says "Not
intended for use as a prybar or chisel,") well then pity may be in
order... :)

Good luck...

Drew MacPherson, Network Analyst, University of Guelph

drew@dyermaker.cs.uoguelph.ca           |  visit the Massey-Harris page:
http://dyermaker.cs.uoguelph.ca/~drew   |  http://m-h.cs.uoguelph.ca


--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org