SV: Mk1 Windshield?

["Roland Johansson" <scirocco@mail.bip.net>]

Bad thing with this method is that those gaskets are much more
rare than windshields.
Method that doesn't break any of them or the car.

You need one person helping you, must be a carefull person.
First from outside "open up" the gasket all way round and then
open op all way on inside so the gasket isn't stuck. Use only
fingers, might hurt your tips slightly but nothing will be
damaged.
Place yourself on one seat and your friend on other seat, start
with one upper corner.
Bend away the seal and push window gentle out, go in both
directions and bend away seal. Window should be starting to come
out. Don't push to hard on window, it might crack.



Roland Johansson
Scirocco 1,6l TIC -82
Http://hem.passagen.se/toker


----------
> Från: Brian Honnold <bhonnold@pac-cap.com>
> Till: 'Sal Guzzo' <yu129742@YorkU.CA>; scirocco-l@scirocco.org
> Ämne: RE: Mk1 Windshield?
> Datum:  den 31 mars 1999 00:56
> 
> Very Very Very carefully cut away the outer rim of the gasket.
 Then you can very very very carefully push the windsheld out.
> 
> It helps a lot if you can get the temperature above 75 degrees
(farenheit) so that the rubber is pliable
> 
> Brian Honnold
> '78 Rocco Ragtop
> 
> On Tuesday, March 30, 1999 5:53 PM, Sal Guzzo
[SMTP:yu129742@YorkU.CA] wrote:
> > How do I get one of these things off without cracking it? 
Can I do it by
> > myself?
> > 
> > Car:  81 Scirocco
> > 
> > Thanks
> > 
> > Sal
> > 
> > 
> > --
> > To unsubscribe, send "unsubscribe scirocco-l" to
majordomo@scirocco.org.
> > If you experience other problems, email:
scirocco-l-probs@scirocco.org
> 
> --
> To unsubscribe, send "unsubscribe scirocco-l" to
majordomo@scirocco.org.
> If you experience other problems, email:
scirocco-l-probs@scirocco.org



--
To unsubscribe, send "unsubscribe scirocco-l" to majordomo@scirocco.org.
If you experience other problems, email: scirocco-l-probs@scirocco.org