Re: Big Valve head on a 1.7L?

[VWN8@aol.com]

In a message dated 3/4/99 09:43:38, weinerman99@yahoo.com writes:

<<I'm a little concerned with any
differences in the oiling area of the equation, do the oil galleys
line up?>>

I've been told that all that really needs to be done is weld shut one or more
of the water holes. I know the big one on the front needs to be sealed but I'm
not sure if there are others. I think TT does this on some of their heads . .
. . or maybe it was Autotech? Anyhow, it's posible.

Nate

--
To unsubscribe, send "unsubscribe scirocco-l" to majordomo@scirocco.org.
If you experience other problems, email: scirocco-l-probs@scirocco.org