Re: Horsepower and torque

["Ian Overholt" <ioverholt@hotmail.com>]

It's probably covered with enough dirt and oil, that you won't get an 
impression from the numbers.  You need to use degreaser or simple green to 
remove the gunk, then you should be able to read the number.

Ian Overholt
'88 16v
'78 Sidewinder


----Original Message Follows----
From: Slim <falzsf@home.com>
To: UrGTI@aol.com
CC: scirocco-l@scirocco.org
Subject: Re: Horsepower and torque
Date: Mon, 23 Aug 1999 17:22:46 -0500

Kewl thanks, now the problem is I cant read my damb code of my block.
According to haynes it is located behind the distributor. I looked there and
I can see where it should be but I cant read it. I tried putting paper over
it and rubbing a pencil on it. nothing, then I tried using a crayon and
rubbing the block, but still no luck!!! Any other places I can find it???

UrGTI@aol.com wrote:

 > For the 85 you have a few choices on HP depending on you engine code
 >
 > GX = 85
 > HT=100
 > JH=90
 > JN=90
 >
 > as for the 16v its
 > 9A=134
 >
 > Jasin
 > 1980 2.0 16v rocco
 >
 > --
 > To unsubscribe, send "unsubscribe scirocco-l" to majordomo@scirocco.org.
 > If you experience other problems, email: scirocco-l-probs@scirocco.org


--
To unsubscribe, send "unsubscribe scirocco-l" to majordomo@scirocco.org.
If you experience other problems, email: scirocco-l-probs@scirocco.org



_______________________________________________________________
Get Free Email and Do More On The Web. Visit http://www.msn.com

--
To unsubscribe, send "unsubscribe scirocco-l" to majordomo@scirocco.org.
If you experience other problems, email: scirocco-l-probs@scirocco.org