Re: Trip Computer Problem

[Ewan Marshall - Frans Maas Linlithgow <Ewan.Marshall@UK.Sun.COM>]

Nicholas,

	  I take it you haven't heard anything about this???
	  
	  I have exactly the same problem and I think it has to do
with me pulling the connectors apart behind the dash when I was taking 
out the sound proofing in my rocco.My clock has stopped at 2.05,which
means that it is still getting a + supply,but no information is getting
through to display on the LCD.Have you touched any wires or that recently
in the (below) dash area??

I'm not sure about this as I have also just had the timing sorted which 
had been affected by the breather pipe (not sure of correct name) :-) 
going to the LCD area in the dash.
Have you had anything done like this recently??

Ewen.


	From: NICHOLAS ISAAC <nisaac@home.com>
	MIME-Version: 1.0
	To: Mark A Peele <scirocco.gtx@juno.com>, yu129742@yorku.ca, 
scirocco-l@scirocco.org
	Subject: Re: Trip Computer Problem
	Content-Transfer-Encoding: 7bit
	
	NICHOLAS ISAAC wrote:
	> 
	> I own an 87 16v and I have a very perplexing problem with it. The trip
	> computer (the screen in the middle of the console with the
	> clock/oiltemp/airtemp etc.) has stopped responding to the selector on
	> the end of windshield wiper control stick. The clock has also stopped 
at
	> 10:45. I tried to reset the clock with the little pin buttons below 
but
	> it didn't respond... Suggestions?
	> 
	> --
	> To subscribe or unsubscribe, send email to 
scirocco-L-request@scirocco.org,
	> with your request (subscribe, unsubscribe) in the BODY of the message.
	
	--
	To subscribe or unsubscribe, send email to 
scirocco-L-request@scirocco.org,
	with your request (subscribe, unsubscribe) in the BODY of the message.


--
To subscribe or unsubscribe, send email to scirocco-L-request@scirocco.org,
with your request (subscribe, unsubscribe) in the BODY of the message.