Mounts replaced and still shaking

[myturbo6 at yahoo.com (Eric Singer)]

Thanks, I'll give that a shot and see if it calms down.
   
  Eric

Patrick Bureau <patrick.bureau@gmail.com> wrote:
  Replacing is one thing, are they aligned properly, if not then you actually
increase vibrations... 

Usually to get best result IMHO, is;

Loosen front and rear mounts, turn engine one let run 1 minute...
Mount rear mount
Where the front one lands, adjust cup so the rubber is perfectly in the
center of it..

Done.


-----Original Message-----
From: Eric Singer [mailto:myturbo6@yahoo.com] 
Sent: Wednesday, March 14, 2007 6:56 AM
To: Scirocco-l@scirocco.org
Subject: Mounts replaced and still shaking

I don't know if this is common or not, since this is the first 16V Scirocco
I've ever owned. I replaced all four of the motor mounts (Talk about your
fun factor). They did help some with the vibration, but when I first start
the car it shakes/vibrates very noticeably. After driving a while it goes
down considerably and not nearly as violent.

Is this just the nature of the beast? Or should I be looking somewhere
else for the cause?

Thanks,

Eric


---------------------------------
Never miss an email again!
Yahoo! Toolbar alerts you the instant new Mail arrives. Check it out.
_______________________________________________
Scirocco-l mailing list
Scirocco-l@scirocco.org
http://neubayern.net/mailman/listinfo/scirocco-l



  
---------------------------------
Looking for earth-friendly autos? 
 Browse Top Cars by "Green Rating" at Yahoo! Autos' Green Center.