[OT] 1990 Jetta, Are you freaking kidding me????!!!

[peter at thescirocco.com (Peter)]

I think that 2nd cast al bracket, may need to come off, but I don't think
you have to remove the axle.
...And the mount should come right out.

Peter  

-----Original Message-----
From: Jason F. Snow [mailto:Jason@xxxxxxxxxxxxxxxx] 
Sent: Friday, July 13, 2007 1:03 PM
To: Allyn; Scirocco List
Subject: RE: [OT] 1990 Jetta, Are you freaking kidding me????!!!

There are two brackets, one that is longer and can come off the tranny, the
other (near the linkage) looks like it is part of the tranny housing that is
the one that is in the way.


-----Original Message-----
From: Allyn [mailto:amalventano1@xxxxxxx]
Sent: Friday, July 13, 2007 12:15 PM
To: Jason F. Snow; 'Scirocco List'
Subject: RE: [OT] 1990 Jetta, Are you freaking kidding me????!!!

Raise the tranny and remove the bracket from it.  That's the best way I can
think to get it out of the way.  The alternative is to drop the entire
subframe.

Al 

> -----Original Message-----
> From: Jason F. Snow [mailto:Jason@xxxxxxxxxxxxxxxx]
> Sent: Friday, July 13, 2007 11:13 AM
> To: Scirocco List
> Subject: [OT] 1990 Jetta, Are you freaking kidding me????!!!
> 
> Dudes and Dudettes,
> 
> WTF - Does anyone know how to remove the drivers side tranny mount in 
> the back? It's a 5 speed 8 Valver.
> 
> I cannot believe it, it looks like you have to remove the axle?
> 
> I jacked the tranny so high that it was touching the body!!! 
> And that's not good.
> 
> The mount is hydraulic and is way taller than the replacement mount 
> (G60 non hydraulic).
> 
> Any suggestions?
> 
> I'm beat down and bewildered.
> 
> Jason
> 
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@xxxxxxxxxxxx
> http://neubayern.net/mailman/listinfo/scirocco-l



_______________________________________________
Scirocco-l mailing list
Scirocco-l@xxxxxxxxxxxx
http://neubayern.net/mailman/listinfo/scirocco-l