Engine ?

[tyrone27 at gmail.com (Derrick floyd)]

if you don't want it and its a 16v slid it my way .

On 1/6/06, chris gonzalez <chris24g@yahoo.com> wrote:
>
> As long as it's been inside, I don't think the corrosion will be very
> deep. It will run. Probably what happened was you didn't cover the intake
> ports, so repeated condensation was allowed to collect and pool around the
> valve opening. It didn't happen to the other ones because the valves were
> open. If you can, pull the head off and wipe off all the gook and inspect it
> further.
>
> ----- Original Message ----
> From: Chad <permitforpyro@hotmail.com>
> To: scirocco-l@scirocco.org
> Sent: Thursday, January 05, 2006 11:22:50 PM
> Subject: Engine ?
>
>
> Was wondering if my 2.0l engine is screwed.  There is some
> rust/corrosion/precipitate on the valve stems and valve seats that I can
> see
> in one or two of the intake ports.  The engine has been sitting for a
> while
> in the garage in this cold weather.  I was wondering if the engine storage
> spray I put into it and the fact that its still turning over by hand is a
> good sign that it will still be ok.  It was running fine when I bought it
> out of a 1991 Passat.  Any ideas or feedback as to what I should do prior
> to
> throwing into the rocco is appreciated.  I was wondering if there is a
> treatment that can be done to the vehicle after install to clean the crap
> out of it or is it just gonna  wreck the motor?
>
>
>
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>