enigne question

[subawrxsti at yahoo.com (levi perkins)]

i was just wondering im just looking for something eaisy and quik to do to get me some more power
Dan Bubb <jdbubb@verizon.net> wrote:  Oh, I think it'll bolt on.
OTOH, the compression ratio, unless you change out the pistons will be ~6.8:1. Too low even for a turbo!
Then there's the issue of crankcase ventilation. The 16V head has no provision for this and neither does the JH block. You'd probably spend a lot of time blowing out seals.
Dan

From: "Patrick Bureau" 

To: "'levi perkins'" ; 
Sent: Tuesday, December 19, 2006 6:48 AM
Subject: RE: enigne question


> No you cannot fit aa 16v head on a JH 8v block
> 
____
> Patrick Bureau, 
> 
> From: levi perkins [mailto:subawrxsti@yahoo.com] 
> Sent: Tuesday, December 19, 2006 3:56 AM
> To: scirocco-l@scirocco.org
> Subject: enigne question
> 
> i have a 8v in my 84 rocc i i was wondering it the 16v head would fit on the
> the block that the 8v head is on?



_______________________________________________
Scirocco-l mailing list
Scirocco-l@scirocco.org
http://neubayern.net/mailman/listinfo/scirocco-l


 __________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com