[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Port matching
- Subject: Port matching
- From: fahrvegnugen at cox.net (David Utley)
- Date: Thu Sep 23 09:38:28 2004
>
> From: Mark <mardak@cogeco.ca>
> Date: 2004/09/23 Thu AM 10:34:35 EDT
> To: fahrvegnugen@cox.net
> CC: scirocco-l@scirocco.org
> Subject: Re: Port matching
>
> David Utley wrote:
>
> > Mark, When I tried to match-port my exhaust mani., I found it way too
> > hard to grind that down without taking tons of time... I was using a
> > pneumatic die grinder... What did you do that I did not? Was your
> > mani new?
>
>
>
> I used a cheapo $18.95 Ebay electric die grinder. You need to use
> stones on the exhaust manifold, but I didn't find it overly difficult...
> My exhaust manifold was (very) well used... Sandpaper rolls won't
> do anything but the final "polish", but a good aggressive stone should
> work ok...
Hmmm, I was using Don's grinder, and it had a metal (I assume tool/tooled steel) bit. So I need a stone for it? Can you buy single stones from Standard Abrasives, or whomever you mentioned?
TIA,
David
---Chrome don't get you home.---