[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

End play

how much do i lossen that #3 cap just enough so i can turn the bolt with my
fingers? then try moving it. How do i ensure when i re tighten it that ihave
it centered. Or does it matter?

Thanks
----- Original Message ----- 
From: "Dave Ewing" <MK1Scirocco16v@comcast.net>
To: <scirocco-l@scirocco.org>
Sent: Monday, September 29, 2003 2:37 PM
Subject: Re: End play


> Yeah, what Dan said, AND, loosen the center bearing cap or the thrust
> bearing cap and check endplay.  There is a very small amount of adjustment
> of that endcap and getting it off center just a hair could be your 1
> thousandths your looking for.  Doesn't the Bentley go into that???
>
> Dave
> ----- Original Message ----- 
> From: "shawn f" <falzsf@mts.net>
> To: "scirocco list" <scirocco-l@scirocco.org>
> Sent: Sunday, September 28, 2003 5:33 PM
> Subject: End play
>
>
> Well i assembled the crank into the main bearing and used white grease. LD
> said not too so i will take it apart and re assemble with the proper
> assembly lubs, OOPS. Now i measure end play and it wasnt even .001 of
> movement and it should be .0028 - .0067. So i guess i need to sand some of
> the side of bearing number 3. It is the one peice one. UI belive that it
was
> i do to increase the endplay. I have to push/pull pretting hard and dont
> even get a thou.
>
> Just double checking this......
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>