[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

End play

Yeah, what Dan said, AND, loosen the center bearing cap or the thrust
bearing cap and check endplay.  There is a very small amount of adjustment
of that endcap and getting it off center just a hair could be your 1
thousandths your looking for.  Doesn't the Bentley go into that???

Dave
----- Original Message ----- 
From: "shawn f" <falzsf@mts.net>
To: "scirocco list" <scirocco-l@scirocco.org>
Sent: Sunday, September 28, 2003 5:33 PM
Subject: End play


Well i assembled the crank into the main bearing and used white grease. LD
said not too so i will take it apart and re assemble with the proper
assembly lubs, OOPS. Now i measure end play and it wasnt even .001 of
movement and it should be .0028 - .0067. So i guess i need to sand some of
the side of bearing number 3. It is the one peice one. UI belive that it was
i do to increase the endplay. I have to push/pull pretting hard and dont
even get a thou.

Just double checking this......
_______________________________________________
Scirocco-l mailing list
Scirocco-l@scirocco.org
http://neubayern.net/mailman/listinfo/scirocco-l