intermediate shaft

[falzsf at mts.net (shawn f)]

how hard are they to install?

I have some pics too, just to make sure....

http://wpggamer.org/inter/index.html

----- Original Message ----- 
From: "Drew MacPherson" <drew@scirocco.cs.uoguelph.ca>
To: "shawn f" <falzsf@mts.net>
Cc: "scirocco list" <scirocco-l@scirocco.org>
Sent: Saturday, October 11, 2003 11:39 AM
Subject: Re: intermediate shaft


>
> If the machine shop used a chemical hot tank to clean the block, then the
> intermediate shaft bearings may well have disolved - requiring new ones to
> be installed.
>
> Drew
>
>
> On Sat, 11 Oct 2003, shawn f wrote:
>
> > I was checking the intermediate shaft and i have major play. Could the
bearing have been removed by the machine shop? I slide it in and it has
major movement on the innner bearing. Is the bearing seperate since it seem
that the shaft moves around quite a bit near the distributor side....Ahhhhh
possible another delay....
> > _______________________________________________
> > Scirocco-l mailing list
> > Scirocco-l@scirocco.org
> > http://neubayern.net/mailman/listinfo/scirocco-l
> >
>
> -- 
> /=============================================\
> |  84 Wolfsburg Edition TurboDiesel Scirocco  |
> |    http://scirocco.cs.uoguelph.ca/gtd       |
> \=============================================/
>
>