intermediate shaft

[drew at scirocco.cs.uoguelph.ca (Drew MacPherson)]

I think they're harder to source than they are to install.  I've never
done it but I believe they can be driven in.

Drew

On Sat, 11 Oct 2003, shawn f wrote:

> how hard are they to install?
> 
> I have some pics too, just to make sure....
> 
> http://wpggamer.org/inter/index.html
> 
> ----- Original Message ----- 
> From: "Drew MacPherson" <drew@scirocco.cs.uoguelph.ca>
> To: "shawn f" <falzsf@mts.net>
> Cc: "scirocco list" <scirocco-l@scirocco.org>
> Sent: Saturday, October 11, 2003 11:39 AM
> Subject: Re: intermediate shaft
> 
> 
> >
> > If the machine shop used a chemical hot tank to clean the block, then the
> > intermediate shaft bearings may well have disolved - requiring new ones to
> > be installed.
> >
> > Drew
> >
> >
> > On Sat, 11 Oct 2003, shawn f wrote:
> >
> > > I was checking the intermediate shaft and i have major play. Could the
> bearing have been removed by the machine shop? I slide it in and it has
> major movement on the innner bearing. Is the bearing seperate since it seem
> that the shaft moves around quite a bit near the distributor side....Ahhhhh
> possible another delay....
> > > _______________________________________________
> > > Scirocco-l mailing list
> > > Scirocco-l@scirocco.org
> > > http://neubayern.net/mailman/listinfo/scirocco-l
> > >
> >
> > -- 
> > /=============================================\
> > |  84 Wolfsburg Edition TurboDiesel Scirocco  |
> > |    http://scirocco.cs.uoguelph.ca/gtd       |
> > \=============================================/
> >
> >
> 
> 
> 
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
> 

-- 
/=============================================\
|  84 Wolfsburg Edition TurboDiesel Scirocco  |
|    http://scirocco.cs.uoguelph.ca/gtd       |
\=============================================/