where to wire in ignition kill switch?

[txrocco at sbcglobal.net (ATS - Patrick Bureau)]

run the 2 wires of ytour switch to one of the positive or ground on the
coil... the engine will turn.. but will not start


ATS - Patrick Bureau - txrocco@sbcglobal.net
Http://www.longcoeur.com/scirocco/
============================================
'85 2.0L Prowler Orange Kamei X1 Rocco
'85 1.8L Titian Red Rocco (daily driver)
'98 4.0L Jeep Cherokee
'91 7.3L F250 diesel Super cab,8 Ft box.



=>-----Original Message-----
=>From: scirocco-l-bounces@scirocco.org
=>[mailto:scirocco-l-bounces@scirocco.org]On Behalf Of Robbie Cotner
=>Sent: Sunday, June 22, 2003 3:33 PM
=>To: scirocco-l@scirocco.org
=>Subject: where to wire in ignition kill switch?
=>
=>
=>I want to just put a simple toggle switch on or near the dash
=>which will make it so my Scirocco won't spark, but the engine
=>will still turn.  What is the easiest way to do this?  My engine
=>knocks after startup unless I crank it over for about 10 seconds
=>first, I'm getting sick of disconnecting the coil wire everytime
=>the Rocco hasn't been started for over an hour.  Thanks,
=>
=>-Rob
=>
=>
=>---------------------------------
=>Do you Yahoo!?
=>SBC Yahoo! DSL - Now only $29.95 per month!
=>_______________________________________________
=>Scirocco-l mailing list
=>Scirocco-l@scirocco.org
=>http://neubayern.net/mailman/listinfo/scirocco-l