Recommeded method for cleaning exposed engine bay wiring?

[Joe.Doty at lcnetwork.com (Joe Doty)]

Simple Green?  It's what I use to clean everything during any swap.

Joe Doty
IT/Development
joe@lcnetwork.com 

> During what seems like my endless fondling of my CIS-E harness making
sure
> I've got it all figured out for my 16v transplant into my cabby, I've
> noticed that several wires have cracks in their insulation relatively
> close to their connectors. Many of these exposed locations have some
> degree of engine bay grime.
> 
> Can someone recommend the proper way to clean these without leaving
> residual solvent or crud?
> 
> For locations that have the wire completely intact, I plan to just use
> some electrical tape and heat-shrink tubing over that once clean. For
> locations that have some fraying, I will solder the exposed area and
then
> proceed as listed above.
> 
> Any input is greatly appreciated (including other tips for preventive
> maintenance on engine bay wiring)!
> 
> Thanks in advance!
> 
> Jeff