[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Back-up switch]



tube from air box runs to an actuator mounted on the front cross member, as
well as a tube that runs from the exhaust manifold (for heated air). there
is a vacuum line that branches from the intake boot to control the actuator,
switching it over to pre-heated air (from around exhaust area), on cold
mornings.
this is usually missing since it doesnt do a whole lot, and we like cool air
at any cost :)
Al

----- Original Message ----- 
From: "Mike Smith" <smithma7@yahoo.com>
To: "Cathy Boyko" <losinit@usa.net>
Cc: "car" <scirocco-l@scirocco.org>
Sent: Tuesday, July 08, 2003 12:31 PM
Subject: Re: [Back-up switch]


> Ok then, here's another question:  I know that the opening on the left
front bottom corner of the airbox is for air to come in.  I had the tube at
one time, not sure if I still do, as I have moved since.  Below the battery,
there's two more openings that go into some black plastic thing.  While
under the cat the other day doing an oil change, I looked at it and it looks
like this thing is where the tube from the airbox connects, so as to get
cold air from under the radiator.  Am I correct?
>
> I wish my ETKA would arrive, as it would sure help with the pics.  :)
>
> Mike
>
> Cathy Boyko <losinit@usa.net> wrote:
> The CIS-E distributor/airbox assembly should be held down by two little
pegs
> at the front, if you take the battery out, I bet you'll see the two holes
they
> slide into, right down where the bottom/back of the battery would be. So
if it
> isn't seated into them properly, it'll move a bit, but it's pretty wedged
in
> there, I doubt it could go very far! So if it's loose, just line up the
pegs
> to the holes and slide the airbox forward to seat them.
> Any other questions, fire 'em my way, this switch I've done, and feel I
can
> help with! Cathy
>
> Mike Smith wrote:
> > OK. I have the switch. I have found where it needs to go. I have big
> hands. The switch is located underneath my CIS-E. (I have 16v). I haven't
> really tried to get in there yet, as I don't want to get that messy just
> trying to see if I fit in there. Will I need to remove the CIS-E or is the
> back-up switch accessable without moving the CIS-E? If I need to move it,
how
> do I do so. I've been looking through Bentley and I have yet to come
across
> an area where it discusses this. Also, my CIS-E moves quite a bit, as if
it's
> not mounted at all, although I can't pull it out, just move it around.
This
> should not be so, eh?
> >
> > Any and all insight into getting at the back-up switch and seating the
CIS-E
> properly would be much appreciated.
> >
> > Thanks,
> > Mike
> > Mars Red '86 16v
> >
> >
> >
> >
> > ---------------------------------
> > Do you Yahoo!?
> > SBC Yahoo! DSL - Now only $29.95 per month!
> > _______________________________________________
> > Scirocco-l mailing list
> > Scirocco-l@scirocco.org
> > http://neubayern.net/mailman/listinfo/scirocco-l
> >
>
>
>
>
> word (w?rd)
> interj. Slang. Used to express approval or an affirmative response to
something. Sometimes used with up. Source
>
> ---------------------------------
> Do you Yahoo!?
> SBC Yahoo! DSL - Now only $29.95 per month!
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>