Rear motor mount compairson

[amalventano at sc.rr.com (Allyn)]

put a stock rear mount back in, vibration will be gone.
same happened to me with the rieger when i tried the vw motorsport mount.
p.s. i run poly front with no issues, not even cracks spreading with a 2.0
installed.
the key is to not let your side mounts go bad - when they do, much of the
engine weight gets applied to the rear and front mounts (and we all know
that the front isnt very happy when this happens).
hth
Al

----- Original Message ----- 
From: "Jonathan Mohan" <astrocowboy5@hotmail.com>
To: <scirocco-l@scirocco.org>
Sent: Thursday, December 04, 2003 11:29 PM
Subject: Rear motor mount compairson


> ok i had some problems with this on the tex so hang with me.
>
> i currently have 4 new motor mounts an autotech poly front, autotech sport
> rear (vw motorsports mount) and the stock side mounts.
>
> there is a little too much vibration for me and i was told to beware the
> poly mount because of the cross member breaking.
>
> i plan on getting a tt HD front mount.
>
> is the autotech rear mount any stiffer than the tt HD mount? i would like
to
> know becaues why replace it if thy are the same.
>
> is this a good setup or should i try some other combination or something
> else first?
>
> thanks
> Jonathan
>
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l