Put driveshaft on and also put on axle nut, but stilldoesn't move

[scirocco at powerlink.net (John C. Worden)]

That's assuming the CV joints are good of course.  If they aren't that 
could be where it's spinning.

John

At 04:35 PM 8/22/03 -0700, L F wrote:

>Either that or get new hubs.  The axle is splined into the hub.  If it's 
>spinning, the splines on one or the other or both are gone.
>
>larry
>
>   Yup get the right axle.
>
>   Andrew Wong <mkii_84@yahoo.com> wrote:Today I got around to loosening 
> the axle nut slightly
>   more than before and putting the bolts of the inner CV
>   in, I don't think I tightened it tight enough, the
>   axle nut and inner CV bolts because when I started the
>   car, and put it in reverse, it did not move still. I
>   looked at the axle and it was spinning like it was
>   wobbling. Any ideas?
>
>   =====
>   -Andrew Wong
>   1984 Black Scirocco
>   1987 White Quantum wagon
>
>   __________________________________
>   Do you Yahoo!?
>   Yahoo! SiteBuilder - Free, easy-to-use web site design software
>   http://sitebuilder.yahoo.com
>
>   _______________________________________________
>   Scirocco-l mailing list
>   Scirocco-l@scirocco.org
>   http://neubayern.net/mailman/listinfo/scirocco-l
>   _______________________________________________
>   Scirocco-l mailing list
>   Scirocco-l@scirocco.org
>   http://neubayern.net/mailman/listinfo/scirocco-l
>
>_______________________________________________
>Scirocco-l mailing list
>Scirocco-l@scirocco.org
>http://neubayern.net/mailman/listinfo/scirocco-l