Mk1 Scirocco Downpipe + OXS

[nealtovsen at yahoo.com (Neal Tovsen)]

As Patrick mentions, if you put the O2 sensor in the
exhaust manifold, do it on the #1 cylinder. That's the
one that is most likely to run lean, if any do.

Neal

--- Patrick Bureau <txrocco@sbcglobal.net> wrote:
> I have a MKI 4-2 manifold + 2-1 downpipe and the
> port
> hole for the Ox sensor is on the manifold, I just
> screwed it right in.. you sure you have the rigth
> manifold ? or maybe there was a set year when they
> started to put them up in the manifold. in anycase
> you
> can drill a hole in it (better get a good drill bit)
> as the one I have is on exhaust #1 piston, about 6
> inches from the head.
> 
> --- Curtis Schofield <schofiel@telusplanet.net>
> wrote:
> > Rocco gals and guys:
> > 
> > Does anyone with CIS-lambda use a mk1 downpipe w/
> > manifold with an 
> > oxygen sensor?
> > 
> > I figured that a hole could be drilled in the
> bottom
> > after the 4-2-1 
> > goes to 1.
> > 
> > Does anyone with CIS-lambda not use the OXS with
> > this 4-2-1.
> > 
> > Is there another place where the OSX can be
> placed?
> > (end of exhaust 
> > manifold? others?)
> > 
> > 
> > 
> > 
> > --
> > Curtis
> > '84 8v Scirocco.
> > '84 8v Jetta GLi (rip '98)
> > 
> > 
> > _______________________________________________
> > Scirocco-l mailing list
> > Scirocco-l@scirocco.org
> > http://neubayern.net/mailman/listinfo/scirocco-l
> 
> 
> =====
> ATS - Patrick Bureau - txrocco@sbcglobal.net
> http://www.longcoeur.com/scirocco/
> ==============================
> '85 2.0L Prowler orangeKamei X1 Rocco
> '85 1.8L Titian Red Daily Driver Rocco
> '98 4.0L Jeep Cherokee
> '91 7.5L Diesel F250 Super cab w/8ft bed.
> 
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l


__________________________________
Do you Yahoo!?
Yahoo! SiteBuilder - Free, easy-to-use web site design software
http://sitebuilder.yahoo.com