pass side engine mount change & injector seals

[scirocco@powerlink.net (John C. Worden)]

--=======666F523E=======
Content-Type: text/plain; x-avg-checked=avg-ok-40D26DA9; charset=us-ascii; format=flowed
Content-Transfer-Encoding: 8bit

At 08:00 AM 10/6/02 -0400, Scirocco-Al wrote:

>Are you sure?  I'm pretty sure the 16V mount was a little larger in
>diameter.
>
>Alan
>----- Original Message -----
>From: <brianm@earendel.org>
>To: "Scirocco-Al" <scirocco-Al@insight.rr.com>
>Cc: "broke" <broke@insight.rr.com>; "T. Reed" <treed2@u.washington.edu>;
><scirocco-l@scirocco.org>
>Sent: Saturday, October 05, 2002 10:05 PM
>Subject: Re: pass side engine mount change & injector seals
>
>
>Uhm any old mount will do.. it doenst have to be a 16v version.. IIRC..
>brian
>damn i need that hood and fender...
>groubmle..
>

Nope, the 16V mount is the same diameter, the difference is all within the 
insert.
Can't remember the difference but offset or size of the metal center piece 
comes
to mind.

John

--=======666F523E=======--