More air shroud questions...

[brianm@earendel.org (Brian McGarvey)]

well mardack.
I have the same setup.
I can tell you that it will work if you cust stick the injectors in the
holes without the plastic thinkie.. at the end of the injector seat. if
you put the o-rings on it. .. yes i know i have it rigged. Can i tellyou
how it will idle. no. i have a bad idle adj screw o-ring.
brian
2.0L topless bunny
2.0L ABA bottom end
38mm GLI (84-85?) 8v hydro head. CIS non shrouded injectors half ass stuck
in the holes.
doesnt idle worht a crap.

 On Sat, 1 Jun 2002, Mardak wrote:

> I've got new non-airshrouded injectors (or are they all the same?), but
> I want to use those with my new setup (2.0ABA w/ JH airshrouded head).
> >From what I've read in the archives all I have to do is remove the
> lower plastic tubey thingy that's below the threaded injector "seal".
> Is this correct?
>
> Correct my thinking if this isn't going to work right:
>
> -Eliminate plastic tubey thingy
> -Using non-airshrouded injectors
> -Using non-airshrouded injector seals
> -Connect shroud "port" on head to the rubber "accordian" piece before
> the throttle body
>
> So will the airshrouding "idea" still work when it's hooked up like
> this (without the tubey thingies)?  Or would it be better to block off
> the port on the head altogether?
>
> Once again, thanks for all your help listers!  The stuff I've learned
> from you guys (and can't forget the ladies!) just blows me away
> sometimes...
>
> Mark.
> 81 S. 2L ABA/JH/4K (rough body doesn't deserve all the goodies :)
>
>
> ______________________________________________________________________
> Find, Connect, Date! http://personals.yahoo.ca
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>