[OT] A1 cabby engine converions questions

[brianm@zbt62.eastnet.gatech.edu (Brian McGarvey)]

<snip due slow connection>
as far as putting the 16v brakes on. I just bolted em on on my stock 90mm
flanges. didn trun into any troubles. straight bolt on.
brian
82 Cabby  -- topless bunny -- lipstick red

>
> For myself, if I was doing this, I'd be swapping the whole loom over
> from the donor car. See how much more work it makes me think of? It can
> be grafted into the existing but---
>
> > Any out of the blue suggestions?
> >
> > What is installed now.
> > EN code engine (1.7L?) FN tranny 90mm axles
> > 16v front brakes
>
> How did you put in the 16v brakes w/ the 90 mm trans?, don't the later
> brakes go with 100 mm everything? (Hey, I don't know _everything_.)
>
> TBerk
>