ABA engine assembly questions...

[marc_scirocco@yahoo.ca (Marc scirocco Québec)]

For the 9A/3A motor (that I am doing), it's all in the
Bentley, let me find out, and will post an answer
later tonight.

Cheers.

Marc

 --- Ron Pieper <rapieper@yahoo.com> a écrit : >
Soo...I'm putting this engine-in-a-box together for
> Big Mac, but have a
> few Q's (I didn't take it apart(:
> 
> -The main bearing shells (block half) consist of 4
> shells with no
> groove and one with a groove.  The block-half shells
> that came out are
> grooveless...is the bearing set wrong  - or - where
> do I put the
> grooved shell half?  (FWIW, from Bentley, #1 main is
> the only one that
> doesn't have an oil galley feeding a rod bearing).
> 
> -Pistons - which way is right?  (These are presently
> disconnected from
> the rods.)  If I hold the piston with the wrist pin
> vertically (that's
> up-and-down for dummies), the stamped numbers 82.485
> and below that, an
> R, in the center of the lower half are readable.  
> Still holding it
> that way, there's a horizontal line in the lower
> left.  In the upper
> right, about 2:00, is an arrow point to the upper
> left with a 495 below
> it.  
> 
> I can install them so that the 82.485 is read viewed
> from the flywheel
> or the timing belt.  Which is right? 
> 
> Thanks
> 
> Ron
> 
> =====
> Cheapass Ron
> "Victor" '87 16V Scirocco
> "Teufelhasen" '93 Cabby <-For sale
> 
> If it ain't foggy, TURN OFF YOUR FOG LIGHTS.
> 
> __________________________________________________
> Do You Yahoo!?
> Yahoo! Sports - Coverage of the 2002 Olympic Games
> http://sports.yahoo.com
> 
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l 

__________________________________________________________
Obtenez votre adresse @yahoo.ca gratuite et en français !
courriel.yahoo.ca