Suspension Poll

[roclist@accessconsulting.ca (Jason Adams)]

I'm running Neuspeed sports with bilstiens, neuspeed front swaybar, 16v rear
swaybar, poly bushings everywhere (except oem front strut bearings). Running
factory wheels with Falkon ZE502's in factory sizes. VERY driveable. This
setup w/16" wheels... you'd better get some sticky rubber, cause there ain't
much body roll, and with no sidewall flex to take up the slack my bet is
you'd be real tail happy .....  not a bad thing ofcourse ;)

oh yeah, I don't know where you live but if you roc's seen salted roads, get
new control arms as well... Trust me it ain't fun when they snap due to the
higher spring rates, stiffer shocks, and years of weakening from salt...
while your at it might as well replace the ball joints as well, you're going
to need an alignment anyway.

Jason Adams
Fahrvergnugen Forever!

----- Original Message -----
From: "Elijah R" <nicadimus@hotmail.com>
To: <scirocco-l@scirocco.org>
Sent: Tuesday, August 27, 2002 8:21 AM
Subject: Suspension Poll


> The time has come to rebuild my suspension. I knew this was comming as to
> the increase bouncieness of the front end, but now as it so happens I was
> bludgend by a pot hole this morning and my pass side front strut has given
> up the ghost and took a rim with it. Soooo, I want to get a mid range set
> up, nothing to extreme. On my MKi's in the past I had a set of Jamex
springs
> on oem 16v inserts which were good but I had no comparission to go by. My
> current wheels are 205/40/16. What do you guys run/recomend???
> TIA
>
> Eli
> 86 16v
>
> _________________________________________________________________
> Send and receive Hotmail on your mobile device: http://mobile.msn.com
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>