series resister replacement?

[amalventano1@comcast.net (Allyn)]

mike,
1. its soldered on
2. i yanked the complete blower assembly and rebuilt it (with Lil B 959 (bryson) a couple of weeks
ago). only stuff removed was the under-dash covers on both sides. there are screws on the underside
holding the blower shroud on, all the rest is under the hood (and the blower itself can come out
from udner the hood, without removing the air handler box). well, you have to remove the center vent
to get to the plug to disconnect the blower assembly. also, its alot easier if you remove the hood
for step 1.
Al


----- Original Message -----
From: "Michael Abatzis" <abatzis2@hotmail.com>
To: <scirocco-l@scirocco.org>
Sent: Tuesday, August 13, 2002 7:16 PM
Subject: series resister replacement?


> blower motor only works on speeds 2 and 3.  replaced the switch, no luck.
> figure it's the resistor. went to pull it from the parts car. 2 problems:
> 1. how do the wires come off the damn thing? they look like spade
> connectors, but they weren't coming off. couldn't get a good look, and
> didn't want to break anything.
> 2. easy enough to get to in the parts car without an interior/dash, but is
> this as big as a pita as it looks like with carpeting, dash, etc still in
> place?
> tia,
> -michael
>
> _________________________________________________________________
> MSN Photos is the easiest way to share and print your photos:
> http://photos.msn.com/support/worldwide.aspx
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l