2.0 16v intermediate shaft

[deadbolt@mindspring.com (S. Coleman)]

Two bearings are in there.   Not very expensive and if the block has been
hot tanked,.. (chemically cleaned),...   then you need to replace them.  A
machine shop can do it for you unless you have a bearing puller.  (Usually
you get two "pullers" when you buy this tool ....  one is about 8 inches
long and the other about 12-14 inches long.)   You can knock them out with a
bearing driver but installing the rear one with this tool is impossible
without an extra long handle.   Your best bet is to pay the $10 or so to a
machine shop and have them put in for you.
GL/HTH,
Chris
'88 16v Rocco
'78 8v Rocco
'80 Caddy
'92 SLC
'02 GTI 337
----- Original Message -----
From: "Dan Williams" <scirocco21@hotmail.com>
To: <scirocco-l@scirocco.org>
Sent: Monday, August 12, 2002 3:13 PM
Subject: 2.0 16v intermediate shaft


> Hy everybody
>
> Does the intermediate shaft on the 16v have bearings?  I know its a stupid
> question, it should but I don't know how to get the bastards out if they
are
> there.
>
> Thanks
> Dan
>
>
> _________________________________________________________________
> Send and receive Hotmail on your mobile device: http://mobile.msn.com
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>