Power Windows

[flaatr@yahoo.com (EUROROC II)]

No problem... tell me where to send it.

-Raffi


At 10:31 PM 4/25/2002 -0400, you wrote:

>I'd love to have this diagram, I'd like to post it on scirocco.org if it's 
>alright...?
>
>==Brett
>
>
>>Same problem here on my passenger window... I just purchased all the 
>>parts to redo both sides from the dealer. The reinforcement plate is 
>>approximately $7, there are also a handful of screws and washers needed 
>>to do it right.
>>
>>There is a diagram too. I'll send a full copy to anyone who needs one. 
>>I've included the text.
>>
>>-Raffi
>>
>>
>>Technical Bulletin 646490T03
>>Dare 900531
>>
>>Power Window Inoperative
>>
>>90vw09
>>
>>Subject:
>>Inoperative Power Window
>>
>>Model(s): Scirocco
>>
>>Group:64
>>
>>Number:64-90-T03
>>
>>Date:May 31, 1990
>>
>>
>>The power window becomes inoperative if the winder mechanism locks up in 
>>the end position of travel (window closed).
>>
>>To repair a window regulator, use the following parts and procedure. 
>>Always modify the regulators in both doors to prevent recurrence of the 
>>problem.
>>
>>Parts required:
>>
>>1 reinforcement plate, P/N 533 837 493 1 each screws, P/N N014 1405 and 
>>N014 1444 2 lock washers, P/N N011 6663 2 bushings, supplied by dealer. 
>>Bushings are made from 20 mm (3/4") thick round steel stock, cut to 10 mm 
>>(7/8") wide with a 6 mm (1/4") hole in the center. See illustration.
>>
>>Repairing Window Regulators:
>>
>>-Remove door panel and carefully remove vapor barrier.
>>
>>-Operate window switch in downward position while an assistant pushes 
>>down on the glass (motor will take over and complete lowering of window glass).
>>
>>CAUTION:
>>DO NOT TAP MOTOR. Damage to the motor magnets could result from such 
>>attempts to get the motor to run.
>>
>>-Move cam bracket (a) into middle of position. See illustration.
>>
>>-Remove regulator mechanism.
>>
>>-Bend sheet metal tongues (b) and (c) OUTWARD to approximately 45~ angle.
>>
>>-Cut end of slide rail (d) 1/2 inch from end and bend to approximately 
>>15~ angle inward toward cable block.
>>
>>-Lubricate slide rail lightly with multipurpose grease.
>>
>>-Install regulator into door.
>>
>>-Install reinforcement plate P/N 533 837 493, to cam bracket (a) and 
>>window bracket.
>>
>>-Install bushing (k) opposite window glass so that it works as a stop in 
>>the curvature (1) in closed position.
>>
>>At 12:24 AM 4/25/2002 -0400, you wrote:
>>
>>>Sounds like you need to buy my motors.......hehe shameless plug to move 
>>>some parts.
>>>
>>>Jasin
>
>\/  '84 Scirocco (ITB racer 2B) | "Hot VW's, take two home. They're small"
>\/\/ '88 Scirocco 16v (Show), '92 Passat 16v (Winter+) | - brett@netacc.net