New Clutch and Flywheel questions

[jdbubb@ix.netcom.com (Dan Bubb)]

NO! NO! NO!
There is no difference in the bell housing between a 4K and 9A
tranmission!
A 4K will work fine with the 3A and the 210mm clutch as will the 90mm
axles.

Some of the misinformation on this list is really starting to bother me!
Let's all work on accurate and knowledgable information.
Dan


Jeff Toomasson wrote:
> 
> I hope you already have the 16v transmission with appropriately-sized
> driveshaft flanges....The 210mm clutch setup won't fit into the 4k bell
> housing (I assuming that's what you have b/c that's what came stock in the
> 84 GTi). And the stock driveshafts are 90mm versus the 100mm for the 16v
> trannys...
> 
> Provide more details about what you currently have and I'm sure we all can
> give you an accurate assessment...
> 
> Jeff
> ----- Original Message -----
> From: <WaspHwy@aol.com>
> To: <scirocco-l@scirocco.org>
> Cc: <mk1gti@egroups.com>
> Sent: Wednesday, April 17, 2002 10:32 AM
> Subject: New Clutch and Flywheel questions
> 
> > I am going to be installing (finally) my audi 3a in my 84 gti. I am gonna
> put
> > a new clutch in (16v PP) and a lightened flywheel at the same time.
> question:
> > do I need to do anything to the motor/trans to prepare them for the 210mm
> > swap, or is it a direct replacement? thanks
> >
> > _______________________________________________
> > Scirocco-l mailing list
> > Scirocco-l@scirocco.org
> > http://neubayern.net/mailman/listinfo/scirocco-l
> 
> _________________________________________________________
> Do You Yahoo!?
> Get your free @yahoo.com address at http://mail.yahoo.com
> 
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l