New Clutch and Flywheel questions

[jtoomasson@yahoo.com (Jeff Toomasson)]

I hope you already have the 16v transmission with appropriately-sized
driveshaft flanges....The 210mm clutch setup won't fit into the 4k bell
housing (I assuming that's what you have b/c that's what came stock in the
84 GTi). And the stock driveshafts are 90mm versus the 100mm for the 16v
trannys...

Provide more details about what you currently have and I'm sure we all can
give you an accurate assessment...

Jeff
----- Original Message -----
From: <WaspHwy@aol.com>
To: <scirocco-l@scirocco.org>
Cc: <mk1gti@egroups.com>
Sent: Wednesday, April 17, 2002 10:32 AM
Subject: New Clutch and Flywheel questions


> I am going to be installing (finally) my audi 3a in my 84 gti. I am gonna
put
> a new clutch in (16v PP) and a lightened flywheel at the same time.
question:
> do I need to do anything to the motor/trans to prepare them for the 210mm
> swap, or is it a direct replacement? thanks
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l


_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com