[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[OT] Tools



Ok. Add the 12 points , but don't forget the 3' extension for the CV joint 
bolts.
The 3mm long shafted allen key for the air/fuel mix.
The whozit that removes the O2 sensor (I just got it!)\
and;and;and;and.....
VW's, tools ARRRRGGGGHHHH!

Julie


>From: T Berk <tberk@mindspring.com>
>CC: aireq@u.washington.edu, Scirocco-l@scirocco.org
>Subject: Re: [OT] Tools
>Date: Fri, 05 Apr 2002 10:36:20 -0800
>
>
> > >From: "Aireq" <trance_whore@yahoo.com>
> > >So now that the weather is starting to get better I'm going to start 
>fixing
> > >up my car / pulling the 16v out of my 16v / figuring out how to get the 
>16v
> > >in my 8v. Anyway I have this 74 piece craftsman tool set that I got for
> > >christmas when I was still in high school. I'm missing a bunch of 
>sockets,
> > >and a wrench or two. So I'm thinking about looking for a new (well new 
>to
> > >me) set of tools. I was thinking about just hitting up goodwill or some
> > >pawn
> > >shops. Or if I buy new I'll probably just end up getting craftsman at
> > >sears.
> > >Any suggestions? Oh I'm in the seattle area btw.
> > >
> > >eric
>
>THEN
>
> > >Julie Macfarlane wrote:
> >
> > 10,13,15,17,19,24 & 30 for sockets.
> > 7,10,13,14,15,17,19 for wrenches.
> > Phillips and a big ass common screwdriver.
> > don't forget the whopper of a hammer.
> > Tool box complete.
> >
> > Julie
>
>Hmmm, that word COMPLETE. (You had to Know we would trip up here).  8P
>
>- Add  that the 30 mm socket should be 1/2" drive or larger, should be
>accompanied by a 1/2" extension (a half inch half inch extension) and a
>matching 1/2" drive 18 inch (or longer) breaker bar.. (For getting the
>axle nut started with the car on the ground.)
>
>- Multimeter (Volt/Ohm). Bonus if it has continuity beep function,
>double bonus id it will do dwell measurements. (In my tool box these are
>two different devices.)
>
>- Dedicated 1/2" (deep) socket, in my case 3/8" drive, to hold the 8 mm
>triple square driver. I have it held in place w/ gaffers tape (like duct
>but oh so more elegant). The need for a small diameter drive here is
>important to clear the CV.
>
>Uh, that's all for now.
>
>TBerk
>
>_______________________________________________
>Scirocco-l mailing list
>Scirocco-l@scirocco.org
>http://neubayern.net/mailman/listinfo/scirocco-l


_________________________________________________________________
Join the world’s largest e-mail service with MSN Hotmail. 
http://www.hotmail.com