RE: wheel bearing question

["Neal Tovsen" <sixteen.volt@verizon.net>]

When I bought new bearings from Potterman, he mentioned this is sometimes a
problem. He sent me new hubs just in case, but I luckily didn't need them.
If you do, they fortunately don't break the bank. I seem to remember they
were about $22 or so...

Neal

> -----Original Message-----
> From: owner-scirocco-l@scirocco.org
> [mailto:owner-scirocco-l@scirocco.org]On Behalf Of Brad Sayer
> Sent: Friday, September 28, 2001 9:43 PM
> To: scirocco-l@scirocco.org
> Subject: wheel bearing question
>
>
> I rented the tool from Rapid to do the front bearings on my car.
> EVerything
> went real easy, but I can't get the inner race off the hub.  Rapid didn't
> mention needing an additional tool, and Scott Williams had said he didn't
> remember needing anything else.  How the hell do I get the inner race off
> the hub then?  I guess I could bring it to a shop tomorrow and
> see if they
> will pull it, or buy new hubs, (but I was hoping to save a few bucks).  I
> can't find a bearing puller type tool that will work at any Autozone or
> Advance auto either.
>
> Brad
>
>
> _____________________
> 1987 16V Scirocco
> vwrocco85@hotmail.com
>
>
> _________________________________________________________________
> Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp
>
>
> --
> Email LIST problems to: scirocco-l-probs@scirocco.org.
> To unsubscibe send "unsubscribe scirocco-l" in the message to
> majordomo@scirocco.org
>
>


--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org