Re: cv's interchangable from auto/manual tranny?

[drew <drew@dyermaker.cs.uoguelph.ca>]

A 92 Jetta automatic would most likely use 100mm flanges.  TN code
automatics used 90 mm flanges, TNA used 100 mm flanges.  I belive the TN
code box was only used up until 1989(?)

Although VW lists separate part numbers for automatic axle assemblies (ie
c/w CV's) I'm not sure what the differences are.  The joints (inner and
outer) are the same 5 speed/automatic for sure.

Drew

On Wed, 28 Feb 2001, Casey Webster wrote:

> Sorry for the non-roc post, 
> 
> Do vw automatic tranny's accept the same axles/cvs as a manual transmission
> car?
> 
> What size flange would a '92 automatic Jetta have?
> 
> Casey
> 
> --
> Email LIST problems to: scirocco-l-probs@scirocco.org.
> To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org
> 

Drew MacPherson, Network Analyst, University of Guelph

drew@dyermaker.cs.uoguelph.ca           |  visit the Massey-Harris page:
http://dyermaker.cs.uoguelph.ca/~drew   |  http://m-h.cs.uoguelph.ca


--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org