Re: Engine Question (compression vs HP)

[Dan Bubb <jdbubb@ix.netcom.com>]

Hate to be a dick, but welding two cut heads together and then
remachining everything (which WILL be necessary due to all the warpage
caused by welding) is going to run in the thousands. Pick any CR pistons
you want from JE for under $1000.
Dan

WaspHwy@aol.com wrote:
> 
> a possibility is to use a head spacer like alot of the honda drag racer's do.
> they basically take a head, cut about an inch or so off of it, weld it to the
> bottom of the head they are gonna use on the car, and bolt it up. it
> apparently works really well, and you can pick the exact compression ratio
> you want to run, for considerably less than low compression pistons
> 
> --
> Email LIST problems to: scirocco-l-probs@scirocco.org.
> To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org

--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org