Re: making CV flange spring depressor (threaded)

[drew <drew@dyermaker.cs.uoguelph.ca>]

Neither, it's metric!  Metric doesn't use NF or NC (national fine or
national coarse) standards, it uses something called thread pitch instead.
If I had to guess from memory I'd say that the thread required is M10X1.5.

Drew

On Mon, 8 Jan 2001, RoccoPhil wrote:

> Wait - I understand the thread is M10 for the flange tool, but is it a fine
> or coarse grade thread?
> 
> -PK
> 
> 
> 
> --
> Email LIST problems to: scirocco-l-probs@scirocco.org. To unsubscibe send
> "unsubscribe scirocco-l" in the message to majordomo@scirocco.org
> 

Drew MacPherson, Network Analyst, University of Guelph

drew@dyermaker.cs.uoguelph.ca           |  visit the Massey-Harris page:
http://dyermaker.cs.uoguelph.ca/~drew   |  http://m-h.cs.uoguelph.ca


--
Email LIST problems to: scirocco-l-probs@scirocco.org. To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org