Re: making CV flange spring depressor (threaded)

["RoccoPhil" <roccophil@mindspring.com>]

Thank you, I was wondering about that in the back of my mind.  Explains why
I got a few different comments as to NF/NC.

Thanks to all.  I am going for a M10X1.5 that is about 6 inches long....

-PK




>
> Neither, it's metric!  Metric doesn't use NF or NC (national fine or
> national coarse) standards, it uses something called thread pitch instead.
> If I had to guess from memory I'd say that the thread required is M10X1.5.
>
> Drew
>
> On Mon, 8 Jan 2001, RoccoPhil wrote:
>
> > Wait - I understand the thread is M10 for the flange tool, but is it a
fine
> > or coarse grade thread?
> >
> > -PK
> >
> >
> >
> > --
> > Email LIST problems to: scirocco-l-probs@scirocco.org. To unsubscibe
send
> > "unsubscribe scirocco-l" in the message to majordomo@scirocco.org
> >
>
> Drew MacPherson, Network Analyst, University of Guelph
>
> drew@dyermaker.cs.uoguelph.ca           |  visit the Massey-Harris page:
> http://dyermaker.cs.uoguelph.ca/~drew   |  http://m-h.cs.uoguelph.ca
>



--
Email LIST problems to: scirocco-l-probs@scirocco.org. To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org