[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Stroker Crank



I my roomate's JH block is running a 95.5mm stroke/82.5mm bore.
I wouldn't imagine there would be much clearancing needed for the 90.5mm
stroke over the 86.4mm.

Randy

----- Original Message -----
From: "Christian Els" <tiAn@usiw.net>
To: <scirocco-l@scirocco.org>
Cc: "Randy B" <sirocco@telocity.com>
Sent: Monday, December 17, 2001 8:54 PM
Subject: Re: Stroker Crank


> How much clearance/interference would one be looking at, adding 4.1mm
stroke
> to an otherwise stock PL..?
>
>
> ----- Original Message -----
> From: "Randy B" <sirocco@telocity.com>
> <snip>
> > For Example:
> > PL/JH/RD -  (stock 1.8L 16V & 8V) 86.4mm stroke/81mm bore = 1781cc
> > PL/JH/RD+ that stroker 90.5mm stroke/81mm bore = 1865cc
>
>
>
> --
> Email LIST problems to: scirocco-l-probs@scirocco.org.
> To unsubscibe send "unsubscribe scirocco-l" in the message to
majordomo@scirocco.org
>
>


--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org