Re: 170k mile 9a prep?

[Shawn C Meze <skerocdriver@juno.com>]

On Thu, 13 Dec 2001 15:06:47 -0600 "Brian Wagner"
<scirocco_88_16v@hotmail.com> writes:
>The trick is to take a smallcotter pin that with fit in the oiling 
>hole in
>the crank. Bend to cotter pin in a "T" insert in the oiling hole and 
>slowly
>rotate the crank the upper bearing shell will come out. To install the 
>new do as the original email said.



Ohhhh. Thats WAY too complicated. Just take a nail (you know, one with a
head on it. No finishing nails here.) and cut off the head so you have
about a 2mm long nail. 

Or

Trim a tack, does the same job. 


Shawn Méze
86' Jetta GLi 8V     84' Scirocco 8V    88' Corvette -SS 30- 2001 SDR
Solo2 Champion
82' Scirocco GTi -FSP 54-     79' "Project FSP Scirocco"
The Fastest, Quickest, Cleanest and best looking Scirocco(s) in all of
San Diego!
http://www.Geocities.com/MotorCity/Speedway/1308/index.htm

________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today!  For your FREE software, visit:
http://dl.www.juno.com/get/web/.

--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org