[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

FW: How to clean Electrical connections (was: Wipers not returning to start)




I'm getting the notion that the wiring and electronics on VW's cause a lot
of problems. What is a good method for cleaning connectors? Is there
something you can put on them to keep them from getting dirty/oxidizing? I
would just think to use a small wire brush, or a dremel with a wire brush
attachment.


aireq

-----Original Message-----
From: T. Reed [mailto:treed2@u.washington.edu]
Sent: Tuesday, August 28, 2001 5:49 PM
To: Aireq
Subject: Re: Wipers not returning to start


Aireq,

I had this problem then I replaced my wiper switch and it went away. I
think it has to do with corrosion and/or wear on the contacts inside the
wiper switch.

HTH,

-Toby

On Mon, 27 Aug 2001, Aireq wrote:

> I asked about this earlier but I can't find the replies. I have a '88 16v
> and the front wipers  dont return to the starting position when you turn
> them off (ie you have to turn them off exactly at the right time otherwise
> they just stay in the middle of the windsheild). Also they only work at
full
> speed not in the timed interval modes . I am asumming that is related to
> them not returning to the starting position. Soooo yeah.. Wudo I do?
>
>
> aireq
>
>
> --
> Email LIST problems to: scirocco-l-probs@scirocco.org.
> To unsubscibe send "unsubscribe scirocco-l" in the message to
majordomo@scirocco.org
>
>


--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org